San Devices E682 Mi...
 
Notifications
Clear all

San Devices E682 Missing Capacitors?

6 Posts
3 Users
0 Reactions
1,676 Views
Posts: 1168
Topic starter
(@keith-r)
Noble Member
Joined: 19 years ago
[#49186]

I have a v1.3 San Devices e682 that was built a couple of years ago and pulled it to test it for a possible prop this year. The board lights up with the 3 yellow LEDs and the WizNet is blinking yellow and green. However, the red and green LEDs do not light and there is no connectivity to the internet. Further inspection reveals that the capacitors under the WizNet, C-13, C-14, and C-15 (0.1uf and 10.0uf), are not populated and the instructions on the web site say these are not presently used. My other e682's are older and are not configured the same. Does anyone have a v1.3 board that is working and can tell me whether or not these capacitors are in place? Thanks.


5 Replies
pmiller
Posts: 2795
(@pmiller)
Famed Member
Joined: 12 years ago

I have a 1.3 board, 2014-03-09 and they are not being used.

Sent from my SM-T710 using Tapatalk


Reply
Posts: 1168
Topic starter
(@keith-r)
Noble Member
Joined: 19 years ago
pmiller wrote:I have a 1.3 board, 2014-03-09 and they are not being used.

Sent from my SM-T710 using Tapatalk

Thanks, I was afraid of that. Have to go through the board a component at a time to see what the issue is.


Reply
Posts: 62
(@lightingfool)
Trusted Member
Joined: 14 years ago

I had a static charge take out the processor. Jim shipped me a new one and problem solved. And yes the red and green LED would not light. New processor, everything came back.


Reply
pmiller
Posts: 2795
(@pmiller)
Famed Member
Joined: 12 years ago
Lightingfool wrote:I had a static charge take out the processor. Jim shipped me a new one and problem solved. And yes the red and green LED would not light. New processor, everything came back.

You mean the large IC propeller? You can get those at your local electronics store. I got a few at Microcenter.

Sent from my SM-T710 using Tapatalk


Reply
Page 1 / 2
Share: