Alphapix 4 port iss...
 
Notifications
Clear all

Alphapix 4 port issue

11 Posts
5 Users
0 Reactions
4,239 Views
Posts: 4
Topic starter
(@iluvlights32)
Active Member
Joined: 12 years ago
[#49181]

I have run shows using the alphapix 4 in past years, but now all the sudden, only port 2 works. In test mode I have tried using all 4 ports and only 2 shows anything. I have even tried switching the cords and no matter what only 2 works. Even tried switching the 7.5 fuses and still only #2 works. Not sure what is causing this.


10 Replies
Posts: 15
(@vwbugjpt)
Active Member
Joined: 11 years ago
iluvlights32 wrote:I have run shows using the alphapix 4 in past years, but now all the sudden, only port 2 works. In test mode I have tried using all 4 ports and only 2 shows anything. I have even tried switching the cords and no matter what only 2 works. Even tried switching the 7.5 fuses and still only #2 works. Not sure what is causing this.

Review the ‘DMX Start Universe’ settings in relationship to the SPI Output settings. If thats OK, try a ‘hard’ or ‘Default’ reset in the setting on the AlphaPix BIOS.


Reply
Posts: 4
Topic starter
(@iluvlights32)
Active Member
Joined: 12 years ago
vwbugjpt wrote:Review the ‘DMX Start Universe’ settings in relationship to the SPI Output settings. If thats OK, try a ‘hard’ or ‘Default’ reset in the setting on the AlphaPix BIOS.

Tried that and even in factory default in test mode only get lights on 2. 1,3,and 4 nothing.


Reply
Posts: 15
(@vwbugjpt)
Active Member
Joined: 11 years ago
iluvlights32 wrote:Tried that and even in factory default in test mode only get lights on 2. 1,3,and 4 nothing.

It is not common but when pixels are incorrectly connected or shorted out, the output chip can become damaged. New output chips can be purchased at HolidayCoro for $ 1.50 plus shipping or you may need to research purchasing a new light controller.

https://www.holidaycoro.com/product-p/625.htm


Reply
Posts: 4
Topic starter
(@iluvlights32)
Active Member
Joined: 12 years ago

I did reflash. I have 12.3v off each output. Here is snip from controller:

AP4config

Reply
Page 1 / 3
Share: