Newbie @ Work with ...
 
Notifications
Clear all

Newbie @ Work with E682

6 Posts
4 Users
0 Reactions
1,897 Views
Posts: 2
Topic starter
(@samson)
New Member
Joined: 8 years ago
[#49193]

Hi All!
first, sorry for my bad english, i'm from Germany and need help about the Sandevices E682.
I have build 5 Window Frames, 2x 180 Pixels, 2x 226 Pixel and Round 100 Pixel.

My Question: On Output 1-1 is a Frame with 180 Pixel, but xlights only control 170Pixel. I know, 1 Univers are 510 Channel.
How i must set the parameters to control full 180 Pixel? In xlights? In E682?

Thanks a Lot!
Merry Christmas - Lights!

sandevice
xlights controller
Layout

5 Replies
TazChaLet
Posts: 3042
(@tazchalet)
Famed Member
Joined: 13 years ago

first off I would change the firmware to the newest firmware this will allow you to set up each port on its own instead of having to set 4 ports at once also you can set the universe to the amount of pixels you want it will show the ending of that port if you look at your picture it tarts at universe 1-1 but ends at universe 2-30 the thing with old firmware is all 4 ports on it are being set to 180 pixels so for the strings that are lower you have problems
this thread talks about it
http://doityourselfchristmas.com/forums/showthread.php?42646-SanDevices-version-5-firmware-information-thread


Reply
Posts: 740
(@ezellner)
Prominent Member
Joined: 11 years ago
samson wrote:Hi All!
first, sorry for my bad english, i'm from Germany and need help about the Sandevices E682.
I have build 5 Window Frames, 2x 180 Pixels, 2x 226 Pixel and Round 100 Pixel.

My Question: On Output 1-1 is a Frame with 180 Pixel, but xlights only control 170Pixel. I know, 1 Univers are 510 Channel.
How i must set the parameters to control full 180 Pixel? In xlights? In E682?

Thanks a Lot!
Merry Christmas - Lights!

Definitely upgrade to the 5.030 release on your E682. http://doityourselfchristmas.com/forums/showthread.php?42646-SanDevices-version-5-firmware-information-thread The information you need is in the first post. The actual procedure is on the SanDevices site. You can have have more than 170 pixels per output on the E682, you just can't exceed the maximum number of channels for the controller. In theory, you could put the maximum number of pixels on one output.
I am not familiar with xLights so cannot answer that part of your question.


Reply
Posts: 335
(@cdanna77)
Reputable Member
Joined: 12 years ago

I believe Taz was trying to link to this thread.the 5.0 E68x firmware. (Sorry if it doesn’t work I’m in my phone)

http://doityourselfchristmas.com/forums/showthread.php?42646-SanDevices-version-5-firmware-information-thread


Reply
TazChaLet
Posts: 3042
(@tazchalet)
Famed Member
Joined: 13 years ago
Cdanna77 wrote:I believe Taz was trying to link to this thread.the 5.0 E68x firmware. (Sorry if it doesn’t work I’m in my phone)

http://doityourselfchristmas.com/forums/showthread.php?42646-SanDevices-version-5-firmware-information-thread

thanks I had wrong window open


Reply
Page 1 / 2
Share: