Notifications
Clear all

rays pixels

109 Posts
36 Users
0 Reactions
27.8 K Views
kychristmas
Posts: 3955
(@kychristmas)
Famed Member
Joined: 18 years ago
Gary Martin wrote:
...
If you want product that's had final testing and burn in, it's going to cost more. In some cases you're talking 2 to 3 times as much as buying bulk product from Ray. While I don't mind doing the QA myself for the cost savings, I can certainly see where others don't want to deal with that and expect commercial grade, fully tested product. If that's what you really want, I'd strongly suggest you buy from one of the commercial, US dealers. They're responsible for the QA testing, for doing fast returns and replacements, etc. Sure, they're going to be more expensive, but that's what you're paying for by purchasing through them.

This one paragraph sums up this entire thread very well.


Reply
Steven010
Posts: 416
(@steven010)
Honorable Member
Joined: 18 years ago
timon wrote:Guys, with Steve having access to an analysis lab I think we take him up on the offer as he has access to better tools than I.

Steve, I'm willing to communication that information to Ray since, I have his ear, plus I have some unencapsulated modules Ray sent me, some of which have failed, that I'll add to the pot.

Sorry, went radio silence this weekend, been building elements and working on display. Now week has started, I have some breathing room.

This will work good, you can discuss options with Ray, I will feed you data. I will post summary details to board also.

I want to make sure I set expectation correctly. On this thread, when I speak about decapsulation, I am talking about the water proof assembly, not the semiconductor. While I can send out part for decap, without the actual mask and capture of the component layers, I would not be able to resolve the results. In other words, since I didnt design this IC and don't know really what is inside part, I wont know what I am looking at after the lab decaps the component and gives me report. The only one that can do that level of analysis is the component vendor. In this case, that is World Semi. I may be able to send part back to them and request a decap from them, but Ray is really in the unique position to request a decap of part (which is actually a fairly complicated and expensive process), as he consumes LOTS of them.

That said, I dont think we are anywhere near needing to requesting a component decap yet. We can learn alot from simply analyzing the assembly and doing tear down and do careful visual study and electrical study. Lets start here and decide the next steps.

Steve


Reply
Posts: 654
(@szaske)
Noble Member
Joined: 14 years ago
MindTrik wrote:Belden item 709SC They do require that you wallow out the hole and it's a tight crimp...but they work!

So these don't truly fit on the 2801 4 wire cables, or they do?

I'd LOVE to buy pixels of higher quality, and from someone who also supplies some custom made crimps for quick on the house repairs. THAT is the business we need.

-=Steve


Reply
jchuchla
Posts: 8698
(@jchuchla)
Illustrious Member
Joined: 15 years ago
szaske wrote:

I'd LOVE to buy pixels of higher quality, and from someone who also supplies some custom made crimps for quick on the house repairs. THAT is the business we need.

-=Steve

i actually looked into making a custom crimp pixel splice connector after last season, but i had a hard time sourcing proper parts that didn't cost a fortune so i dropped the idea in the spring.


Reply
Page 22 / 22
Share: