Raspberry Pi heat s...
 
Notifications
Clear all

Raspberry Pi heat sinks?

9 Posts
7 Users
0 Reactions
1,979 Views
Posts: 23
Topic starter
(@oldcaptainrusty)
Eminent Member
Joined: 9 years ago
[#49740]

Should I install the heat sinks that come in the Canakit pi kit. Pi will be running in an enclosure with vent holes along with 2 12v power supplies and an E682 controller. It will be running a 32 string mega tree with 50 pixels per string. What are your thoughts. Thanks in advance for your time.


8 Replies
MartinMueller2003
Posts: 7615
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

Will it hurt to have those heatsinks installed? If they fit in the case then I would install them. I have installed them on all of my PIs. I do not think they are absolutely required, but a bit of insurance can go a long way where heat is concerned.


Reply
Posts: 140
(@mister-softee)
Estimable Member
Joined: 9 years ago

have you run with the power supplies next to it for a good amount of time with no issues? Me myself put the pie in a 1500 enclosure with one power supply and after about 2 hours the show shut down. The pi got too hot from the power supply. Now I run the pi in a separate container and have had no no issues with it for multiple hours. Just asking...


Reply
Posts: 740
(@ezellner)
Prominent Member
Joined: 11 years ago

I'd install them since you are in a warm weather area. If you were in the north with temps typically below 40 degrees for the show season, you could probably get away without the heat sinks.


Reply
jnealand
Posts: 956
(@jnealand)
Prominent Member
Joined: 19 years ago

I'm in Atlanta area. Been running Pi for several years, 9 FPP remotes last year. Most are in marine battery boxes sitting above two 350w power supplies. Some are in CG1500 with 1 PSU. I have never installed a heat sink and have never had an issue that would require them. In fact I have never even seen/own one. Just my 2 cents.


Reply
Kev7274
Posts: 2037
(@kev7274)
Famed Member
Joined: 13 years ago

I always install the heat sinks.


Reply
Posts: 140
(@mister-softee)
Estimable Member
Joined: 9 years ago
ezellner wrote:I'd install them since you are in a warm weather area. If you were in the north with temps typically below 40 degrees for the show season, you could probably get away without the heat sinks.

I agree my temps are about 75-80 degrees, this time of year in the daytime. In 40 it might work perfectly fine


Reply
Posts: 23
Topic starter
(@oldcaptainrusty)
Eminent Member
Joined: 9 years ago

Thanks gentleman for the input. I appreciate your time.


Reply
Posts: 299
(@dcamron)
Reputable Member
Joined: 10 years ago

The only issues I’ve ever had with a PI shutting down was due to low amperage. The PI will run but gets real screwy when it’s short on power. I also run my Pi’s in enclosures with a power supply and no issues.


Reply
Share: