Cluster is a group of 4 connectors to plug strings into, that must be all the same chip type (2801, 2811) and same voltage (provided voltage is from the controller).
Skunberg wrote:Cluster is a group of 4 connectors to plug strings into, that must be all the same chip type (2801, 2811) and same voltage (provided voltage is from the controller).
this is correct , each universe has 4 sockets refered to as clusters .
within the web config utility users define all atributes for each cluster .
chip type < once this is set it effects the whole universe/all 4 clusters
string amount < = number of sockets/clusters to use
pixel amount = numberof pixels /cluster
grouping
null pixels
rgb color order
dmx address order < this one I have not used
I may have missed some attributes , but this should give you an idea .
P. Short wrote:What are the restrictions on grouping, in terms of the number of pixels in each group and the number of groups per Universe (or whatever intermediate association there may be)?
In another thread, jstjohnz said the limit for the E682 was currently 512:
jstjohnz wrote:I think there is a limit, somewhat arbitrary, of 512 physical pixels per string. One string can use more than 1 universe. So you could have a 512 pixel string with no grouping. Keep in mind though that the refresh rate drops as the string length increases.
don
I don't mean to be rude, but Richard1 is confusing all of the terminology by using the wrong words to describe the various setup items on the board.
1. A socket refers to an a virtual Ethernet path used by the board. You can assign different physical DMX universe numbers to each socket. There are 6 sockets on a E682 board. I think an E681 has 4 sockets. I don't own an E681, so someone correct me if I'm wrong.
2. A cluster refers to a set of 4 connectors that are used to connect your pixel strings to the board. You can assign a socket (and thus, its associated universe) and a starting DMX address to each cluster.
3. A cluster can end up spanning multiple universes. For example, you could connect qty 4 50-pixel strings to a single cluster (one to each of its 4 connectors), for a total of 200 pixels on that cluster. That would require 600 DMX addresses. Thus, more than one universe on that cluster. If you started the cluster on universe 1, address 1, and had universe 2 assigned to the next socket, those pixels would span from Unv1-001 to Unv2-090.
4. A single universe can span multiple clusters. In the above example, the last 30 pixels would consume 90 addresses of the next assigned universe, as you can see. You could start cluster 2 on Universe 2, address 091.
5. For clarity on the OP, GRoup is a command that allows groups of pixels to be assigned the same DMX address, if that's what you'd like to do. For example, if you used a grouping of 2 on a string of 50 pixels, you would only consume 25 RGB addresses (75 DMX addresses), as every 2 pixels would be told to behave exactly the same way.
Thanks, aaron1. That makes sense.
What is the domain of a grouping assignment? The entire cluster, a single string (meaning the string(s) attached to one output connector), a universe, or something else?
