Thanks. I can use either 5v or 12v. I just wanted to be sure before I tried 12v and fried the board. 🙂 What pins did you use to connect the pixel...
yohan wrote:I have purchased one of these A+ NodeMcu Lua ESP8266 ESP-12E CH340G WIFI Internet Development Board Module from ebay. . Then flashed fir...
With all the problems with LOR S4, I'm guessing that some folks (myself included) have opted to stick with S3. Is it one that you can add? It will b...
Depending upon what LOR hardware you have, you may or may not need to use the hardware utility to set the DMX address. If your controller is a CTB16D...
BTW... My comment on the crossover cable above may only be required if you're using the LOR RS-485 dongle. Here's a link that shows the crossover wiri...
Where are you setting the LOR address? Your controller needs to know what DMX channels to look for. I don't use mine in DMX (yet), but you have to tel...
I like the grommet idea. I was planning on the same thing. I used the strapping for the last couple years. Unfortunately, I ran into a very bad bat...
Sale pending.
Is there a reason I couldn't use a "bottom" at both the top and the bottom of the tree? I already have a hook head that I used this past year. It's ...
If it's not too late, I'd like 70 of the black ones. Thx.
I'd still like the small ones. I'm considering building a few for peoples' desks (OK, maybe just me and the wife) at work. 🙂
Damn. I'm probably too late. I'd like 10 of the small ones.
