Question about E682...
 
Notifications
Clear all

Question about E682 Zigzag Configuration

4 Posts
2 Users
0 Reactions
1,693 Views
Posts: 825
 DanJ
Topic starter
(@danj)
Prominent Member
Joined: 13 years ago
[#38712]

I posted this at the ACL forum, too....

I am setting up my megatree lights (5m WS2811 strips, 30 LEDs/m 10 pixels/m) with my E682 to check out all my channels and I when I use SACNView to channel check I am seeing something I did not expect. I had expected the first strip coming out of the "1-1" socket to contain channels 1-150, then the second strip wired up in series with that strip to contain channels 151-300, but I am seeing the reverse of that. That was totally not expected....
I attached a snip of my channel configuration.

Any help anyone could provide would be GREATLY appreciated!!!!


3 Replies
JCook
Posts: 1003
(@jcook)
Noble Member
Joined: 13 years ago

You didn't post a picture.

Something to think about is how did you patch them? Did you just select the tree then the controller and let it patch? Are the strings in your Display setup in the same order as the they are physically? If the strings in the setup are not in order and you didn't patch string by string then maybe that is the issue. Using 50px per string did you set the zigzag to 50?

If you setup the E682 for 100 pixels per output then 1-1 would be 1-300. 1-150 for your first set of 50 then 151-300 for the second set of 50.

if this doesn't help then post a screen shot of your E682 setup and your display setup. What software are you using? Vixen 3?

Jay


Reply
Posts: 825
 DanJ
Topic starter
(@danj)
Prominent Member
Joined: 13 years ago

I tried (unsuccessfully I guess) to post a screen shot.... I figured it out--I had correctly set zigzag to 50 but I had clicked on "reverse"--that was making the strips swap with each other apparently. I am using xlights. I set the pixel lengths to 100 on the sockets that have series strips connected to them; that worked exactly as I expected

Thanks very much for the help!!!!


Reply
Posts: 825
 DanJ
Topic starter
(@danj)
Prominent Member
Joined: 13 years ago

Ok--followup question. I finally got some universe issues resolved and I am walking through all my sequences to make sure everything works correctly. All eight strips on sockets 1-1 thru 1-4 are wired in series; these are the ones I am zigzagging. When I test the channels using SACNView, the strips are clearly setup correctly because they transition from the end of the first strip (for example) to the beginning of the second strip (and so on for all eight strips) as I run thru the channel checks. However, when I am watching some of the XL/NC effects, it looks like I need to reverse some of these strips--especially for garlands, bars, meteors, and others that have a lot of movement to them. Any ideas? As stated in previous post, I have the first set of sockets set to 50 pixels, zigzagging every 50 pixels.


Reply
Share: