ESPixel GECE Info T...
 
Notifications
Clear all

ESPixel GECE Info Thread

123 Posts
28 Users
0 Reactions
51.3 K Views
Posts: 911
Topic starter
(@madsci1016)
Noble Member
Joined: 12 years ago
[#38693]

Hello all. This is a information thread on the ESPixel GECE WiFi adapter. It is a drop in replacement for the GECE/iTwinkle control board. It will convert a strand of GECE pixels over to receive e1.31 sACN control data over WiFi. This lets you use stock power supply and enclosure. No more throwing away perfectly good 5V power supplies. No more CAT5 running to a master pixel controller. Use the GECE/iTwinkle strands as intended, but with a useful controller!


Right now the ESP on board runs sporadic's ESPixelStick firmware unmodified. He's worked hard to create code that runs both WS2811 and GECE pixels. The boards can be re flashed with a FTDI board if need be. Configuration is managed by web interface just like ESPixelStick.

I'll post assembly instructions shortly. Please use this thread to ask questions about the board. I'll update this post as necessary.

Bill


122 Replies
Posts: 4092
(@skunberg)
Famed Member
Joined: 18 years ago

Will there be a group buy this year?


Reply
Posts: 2048
(@scootchu)
Noble Member
Joined: 17 years ago

I sure hope there is. OR at least the need for some beta testing. 🙂 I have most of the parts already, boards would be so cool.


Reply
imbluenote
Posts: 1615
(@imbluenote)
Noble Member
Joined: 15 years ago

that would be cool. glad i kept all the controller boxes i cut off!


Reply
Robo
Posts: 1494
 Robo
(@robo)
Noble Member
Joined: 14 years ago

I'm not tech savvy at all really, but what do you use to control these an app on your phone? Could these be setup to run from the FPP or typical pixel controllers?


Reply
Page 1 / 25
Share: