Problem with E681 a...
 
Notifications
Clear all

Problem with E681 and 12V 2801 Pixels - Need Debug Help

2 Posts
2 Users
0 Reactions
1,275 Views
kidcole
Posts: 307
Topic starter
(@kidcole)
Reputable Member
Joined: 17 years ago
[#23222]

I found an odd issue with my E681 and two different types of 2801 12v pixels. (Strips and Modules). The second output of of the 3rd Universe on one of my E681s will not work when connected to "some" strips or modules. This started when I fired up my first pixel tree made of 2801 strips (12v 3 5050 LEDs per pixel). The whole strip flickers with very low intensity .. But when I put the same strip in any other output of the same E681, the strip works fine. I also tested other strips in that same output and they worked fine. My tree is already built to the point where I cannot move the strip, so I had to swap out the E681 instead.

Part 2 - I added my CoroFlakes in the show last Friday night. These are configured with 10 pixel modules per leg (50 pixels total). Each pixel module has 4 5050 LEDs and run 12v 2801s. I had to use the E681 with the output that flickered. And once again, that same channel was flickering badly, but now with the modules in one of the CoroFlakes. I swapped other modules into the "bad" output and once again they work fine. Once again I did not want to address my channels backwards from the way I physically mounted all the pixel in the flakes. I took out the E681 and checked for any bad solder joints. And I shotgunned everything related to that 3rd universe plus the main chips, etc. All solder joints looked really good before I shotgunned them. Not knowing exactly what the ICs are doing that are plugged to each Universe, I also swapped a few around since they are all the same. AND I swapped the resistor banks around. I made sure that everything related to the 3rd universe is different (except the chip socket). Sadly the same result. The same output is bad, but only with the one set of modules that "need" to be connected to it. Murphy is living inside this E681 !

I have a spare Universe on this E681, so I configured around the problem. But it really bugs me that I cannot use that Universe anymore. I would like to get back to a clean configuration and resolve this problem so I can expend the use of this E681 for next year's display. This problem is always with the same channel, but now with completely different wiring, connectors, etc. It seems to follow the hardware but only with some pixels. This makes no sense since other pixels work fine. All wiring has been triple checked.

Could this be a firmware or 2801 timing issue ?


1 Reply
Barnabybear
Posts: 1583
(@barnabybear)
Noble Member
Joined: 15 years ago

Have you got the jumper at the side of the buffer IC set into the 5V postion on the 3rd universe?


Reply
Share: