Notifications
Clear all

Pixel tree

14 Posts
6 Users
0 Reactions
6,257 Views
Posts: 68
Topic starter
(@wootin24)
Estimable Member
Joined: 15 years ago
[#23262]

Ok, I have the idea of doing a small pixel tree for next year and need to know how it could best be done. i want to make it 8ft tall and have 10 strings of 25 pixels on it. i also want it to be only 180 degrees so that in can use less pixels. my question is, how would i go about building it. i want all the pixels to point out and my first idea was to make the tree with legths of pvc for each string and then hook the pixels to that. is ithere any better and more cost effective way of doing this. i live close to the road so i think that 8ft tall and a 4ft base will work, thanks


13 Replies
Barnabybear
Posts: 1583
(@barnabybear)
Noble Member
Joined: 15 years ago

Mine is like this -it is so high off the floor as I have a 6ft high wall around my garden - so from the road you can only see the bottom row of pixels.



The steel strip is this http://www.less2fix.com/Fixing-Band-Builders-Band-20mm-10mtr
I had to open up the holes to 12mm - I stacked the band and drilled through 32 strips at a time.


Reply
Posts: 1792
(@barbotte)
Noble Member
Joined: 17 years ago
Barnabybear wrote:Mine is like this -it is so high off the floor as I have a 6ft high wall around my garden - so from the road you can only see the bottom row of pixels.



The steel strip is this http://www.less2fix.com/Fixing-Band-Builders-Band-20mm-10mtr
I had to open up the holes to 12mm - I stacked the band and drilled through 32 strips at a time.
Keep looking at post as, I think, I am the only person using this design.

hey i like the idea ..of those strip ... but will they be strong enough to do a 24 ft tree???
thanks


Reply
Posts: 68
Topic starter
(@wootin24)
Estimable Member
Joined: 15 years ago

I like the strips as well but I was wondering, is there a place to get them in the US?


Reply
tom4writer
Posts: 85
(@tom4writer)
Estimable Member
Joined: 16 years ago

Try McMaster.com. I used some poly strapping for my pixel strips. I just zipped tied the strips to the strapping. To make the loop i just folded the ends over and used a hole punch on both sides of the loop. I put a couple zip ties to hold the loop closed. Seems to work good. I tried to break it apart by pulling hard on it and the loop didn't break.

http://www.mcmaster.com/#catalog/118/1572/=kok47r


Reply
Page 1 / 3
Share: