well im trying to get these to work and having issues making them work with lsp. if i use da_e131 from acl i get all to work. if i use lsp test channels the first one doesnt light and the last half of the string doesnt light. so what am i missing?
i have it running 36 pixels on univ 3. so all that is set right.
so please tell me what im doing wrong.
thanks
I had problems with the ge lights if the distance to the first pixel was more than about a foot. The first pixel would get the wrong start address.
One thing to check.
Make sure the strings are defined correctly on the E680/681. By that, I mean if you have 36 pixels, then be sure it's set for GECE and 36 pixels in that cluster on the E680. And save the settings on the E680.
Now cycle the power of the controller/pixels.
I found you need to cycle the pixels after the settings are correct on the controller. Otherwise you get weird behavior.
Now, it's entirely possible that the E680 may not be able to drive the GECEs correctly without the voltage modification (if you've got v1 boards) or without the jumper in place on the V2 boards when you have some distance to the first pixel. I haven't tried mine with any distance on my E680. On an E681, I had a pigtail of at least 3 feet and a single string of GECE's worked without a problem.
As I recall from some of the old posts was that the GE's were fairly loose wrt to distance and could go like 20' but I could be wrong. Can you describe your power supply configuration?
thanks guys for the tips.
it is the newest v2 board and the jumper is set. i have it on socket 3, univ 3. with 36 pixels with start address of 1.
the distance from board to first pixel is about 8in. i have a 5v 6 amp power supply on the e680 with the power for the pixel comng from the e680.
if i use the da_e131 from david avd it works great. once i try lsp and vixen it does the same thing.
