Problem with E680 ...
 
Notifications
Clear all

Problem with E680 and GECE pixels

21 Posts
8 Users
0 Reactions
7,964 Views
Posts: 2171
(@mschell)
Noble Member
Joined: 18 years ago

If you have it very close to the E680 and it works with DA-e131, then the board setup is fine.

You obviously are doing some thing different with the plug-in setup on LSP and Vixen.

perhaps a screen shot of the plug-in setup and your channel layout might help shed some light on the problem.

You can also try out SACNview. It has a signal generator that can output like da_e131. But I'm guessing that it's a plug-in problem.


Reply
Posts: 1372
Topic starter
(@fathead45)
Noble Member
Joined: 18 years ago

ok after playing with the arch i setup da_131 is not working the way i thought. if i use it to turn on all channels to 1 color it turns them on an looks fine. but if i try the chase i can 2 pixels going at the same time in unison on diff parts of the string. its weird. i cant figure why it will turn them all on fine with just 1 color but not work with the chase. also the test on the e680 work with 1 thru 3 but after that is just hangs up and wont do the chasing for like 4 mins after i select it.

i guess it comes down prob the programming in the e680. ill try to get screen shots.


Reply
Posts: 1372
Topic starter
(@fathead45)
Noble Member
Joined: 18 years ago

heres the pics. im using socket 3 with 36 gece only.

e680controller
lsp
lsp1

Reply
budude
Posts: 10400
(@budude)
Illustrious Member
Joined: 18 years ago

E680 config looks OK to me... can't speak for LSP - I know it handles RGB devices but should it be 36 channels or the full 108? Did you try SACNView?


Reply
Posts: 1372
Topic starter
(@fathead45)
Noble Member
Joined: 18 years ago

it will be 36 ch and then beside it says 108 physical channels. so that is good.

no i ill try sacnview later or tom.


Reply
Page 2 / 5
Share: