Power supply for e6...
 
Notifications
Clear all

Power supply for e682

5 Posts
4 Users
0 Reactions
1,986 Views
Posts: 93
Topic starter
(@quefol)
Estimable Member
Joined: 18 years ago
[#35214]

Hello Next year i have decided I'm going to start using pixels i want to use the e682 for a 12 ccr superstar I have a good grasp on how to Set up the e682 just trying to figure out what power supply I'm going to need im going to use the ws2811 5meter strips It says they consume 10w per meter so 50w per strip I'm going to use the first 3 clusters for the strips and the last cluster to output dmx for my other controllors so the first 2 clusters would need minimum of 400w and the 3rd cluster would need 200w is that correct if so would need 2 separate power supplies Thanks


4 Replies
Posts: 503
(@iflights)
Honorable Member
Joined: 14 years ago

You will need 2 PS or one very large 600W PS. Your calculations seem to be right on.


Reply
Posts: 93
Topic starter
(@quefol)
Estimable Member
Joined: 18 years ago

Thanks would It be wise to get a larger wattage power supply so I'm not maxing out the wattage or would 400w be ok I know were I can get 400w supplies fairly cheap


Reply
OregonLights
Posts: 736
(@oregonlights)
Prominent Member
Joined: 16 years ago

I would consider a single power supply with a higher voltage and DC-DC buck converters. This will help overcome distance issues, reduce wire size and reduce the power supply size too.


Reply
Posts: 73
(@ratroder)
Trusted Member
Joined: 17 years ago

A large computer power supply would work well.


Reply
Share: