Power Injection Tee...
 
Notifications
Clear all

Power Injection Tee Question

5 Posts
5 Users
0 Reactions
1,527 Views
Posts: 16
Topic starter
(@mikev)
Eminent Member
Joined: 6 years ago
[#53467]

I have been splicing power injections myself and I wanted to quickly power inject a handful of my props using power injection tees to help me save some time. My question is--do I need to remove the data (third pin) pin from the tee? I watched a video from Holiday Coro and he removed the data pin. I know not to connect my data wire when going back to my power supply (I'm using f8 distro board from falcon). If I do not remove it will it cause the data to run improperly?


4 Replies
rstehle
Posts: 4348
(@rstehle)
Illustrious Member
Joined: 19 years ago

No, it is not necessary, as long as you be sure to not hook anything to it :biggrin2:


Reply
Posts: 98
(@nayrma)
Estimable Member
Joined: 9 years ago

No pin removal but make sure you understand the wiring of the T. I bought some from Ray Wu where the positive for the PI ran back along the PIN that is normally used for data. That threw me for a total loop. My case may be unique but sharing to avoid my pain

Sent from my SM-N960U using Tapatalk


Reply
Posts: 528
(@bud29)
Honorable Member
Joined: 17 years ago

Yup, ring it out and make sure you know what goes where. I've bought T;s from the same vendor in different years and even though they look exactly the same, they have different pin connections. As mentioned, as long as you remember how you wire it is the important thing.


Reply
Posts: 451
(@utimgr)
Honorable Member
Joined: 14 years ago

However...even though the speed of the data line is quite slow, having a data line floating out there is considered a stub connection, so it can/might/could affect the signal integrity causing problems. I would try and keep the data lines clean, and just feed it to the first pixel and nothing else.


Reply
Share: