so im going to be switching from arduino mega's to 1 or 2 pixel sticks this year. im aware each stick can handle about 1024 pixels which is about 3000 channels...is this correct? also im curious how i would be able to run multiple elements off one board. such as say...left window, left 2, door, bay window ect...all off one pixel stick. is this possible? how would i connect the data lines from each to the stick?
pixels are daisy chained up to 1k in a string. Data out from the last pixels on an element goes to data in on the first pixel on the next element via a wire pair. You can inject power at each element.
The same as most all controllers, however distant between elements could be an issue.
I run several arches off 1 ESPixelStick....in one end, and out the other....about 8 feet, then the next Arch.
You should stick to around 640 pixels per stick (you can do more but your refresh rates will suffer). Its possible to do multiple elements of one 'stick' but you may need null pixels if the elements are not close together (you can only run one port/strand/string from the pixelsticks).
It would probably be easier to use a single controller for each element if the distances are too great. ESPixel's are ~$9... That's a small price for convenience & simplicity 🙂
TheLost wrote:ESPixel's are ~$9... That's a small price for convenience & simplicity 🙂
Last I saw the ESPixelsStick is selling only at amazon and about $20 - out of stock
Renard Plus ESP WiFi Pixel from Renard Plus Shop is $12
