Looking for some advice on putting pixels on railings. Right now I have super strings of Red, Grn, Blu, Wht & Multi outlining all the railings. Looks real good and can do a lot of color and intense flashing effects but I'm thinking about going to Pixels or at least adding them. So my question is how would you do this if starting from scratch (no super strings). I was thinking I would do outlines (tops bottoms and sides) like I'm doing now. But then I want to do all the inner vertical bars too so I can hopefully get some cool sweep and wipe effects with that.
So if I go up, over, down, over, up, and repeat then I will have the vertical bars covered but will also have potential unwanted pixels in the middle of the bars. I suppose I could tape those off if not easy to account for in sequencing program or maybe it wouldn't be that noticeable (bar spacing is about 4.5"). But by having all the vertical bars individually controllable I think I could do some cool effects on the railings.
I haven't used pixels except for a outline STAR I made and wrote Arduino code using Renard SS8 as triggers to do 8 different patterns. So I really have a big void when it comes to Vixen3 or XLights as how to do this sequencing. I still need to buy the Pixels, Controllers, Power Supplies too and just trying to get an idea how it work before making the investment. I'll probably just get the stuff and wing it but any thoughts on this would be much appreciated!
Forgot something about positioning... it it best to get those pixel alignment strips or is tie wrapping the strings good enough (do the pixels need to be pointing straight out for best effect?)
Thanks!
Pixel strings can be cut to size. Pixels have a 145 degree viewing angle with straight on being the best. Alignment can be done any way your want. Boscoyo strips work well to maintain alignment and spacing. If you have a fence rail then you have the perfect place to make a matrix.
Thanks for your quick response. I guess I could cut 2811 strips for each vertical bar but that's like 80 strips and 80 connectors to wire up. But maybe that's not a bad idea to do it once and then it would be easier to put up every year and probably maintain too. This is the kind I stuff I need to think about so really good of you to point that out. Also, maybe a flat pixel strip is better than the 2811 for the bars and I think I need to look into that.
You could buy some Boscoyo matrix panels, cut them to fit the stair railings and then pop ws2811 square or bullet nodes in at whatever spacing you want. That would keep them pointed the right way and also give good even spacing across the whole area. The panels would allow easy setup and tear down, you just need to worry about storage.
Thanks I'll check into those panels!


