Pixels Light Up Fai...
 
Notifications
Clear all

Pixels Light Up Faint Red - E682

7 Posts
6 Users
0 Reactions
1,903 Views
Posts: 6
Topic starter
(@whalen-dan)
Active Member
Joined: 12 years ago
[#38281]

I'm running across a new problem that I previously did not have. I've been building some pieces to mount underneath the eaves on my roof-line, and when I went to re-test the finished pieces I discovered that every run of pixels lights up a faint red by just being plugged in. This happens no matter which output the strand is plugged into.

Some details about the setup:
Controller - E682
Pixels - WS2811 bullet style pixels, 12V
It makes no difference how many pixels are plugged in. I've tried as few as 3 pixels and a never been touched strand of 50.
I've tried having them plugged in and my computer off to make sure there was no possibility of multiple signals being sent at once.
I've restarted the controller.

What's odd is that if I do run the test patterns on the SanDevices system page in my browser, they run through just fine. Just when the pixel should be off. it's a faint red. I've been testing pixels all summer and even a couple weeks ago and was not running into this issue. Seems like a power or controller issue, but I'm new to this and really do not have an idea where to start to further isolate the issue.

Any suggestions?

Thank you!


6 Replies
MindTrik
Posts: 1542
(@mindtrik)
Noble Member
Joined: 16 years ago

Test the voltage on your power supply and see if it's too high. I had the same issue with some floods

Sent from my LG-H811 using Tapatalk


Reply
Posts: 6
Topic starter
(@whalen-dan)
Active Member
Joined: 12 years ago

Sorry, forgot to add in that I've tested every output on the controller. Everything is at 12.19V when testing directly on the controller, and the power supply outputs are right at 12.19 as well.


Reply
TazChaLet
Posts: 3042
(@tazchalet)
Famed Member
Joined: 13 years ago

I have seen some say that some pixels are more touchy than other so the 12.19 might be just high enough for the pixels too react if your is adjustable back it down too closer too 12v and see if it helps


Reply
Posts: 209
(@rick-todd)
Estimable Member
Joined: 14 years ago

I just had the same problem witha E6804 using a 12 volt wall wart. As soon as i switched to a 12 volt power supply the problem went away.


Reply
Woody929
Posts: 30
(@woody929)
Eminent Member
Joined: 12 years ago

I also had the same problem when the voltage was a bit to high


Reply
Posts: 8517
(@angus40)
Illustrious Member
Joined: 15 years ago

Just a thought .
Check the 220/110 switch 🙂


Reply
Share: