Pixel Window Frames
 
Notifications
Clear all

Pixel Window Frames

7 Posts
4 Users
0 Reactions
2,121 Views
gassy
Posts: 548
Topic starter
(@gassy)
Honorable Member
Joined: 17 years ago
[#27691]

Attempting my first project with pixels and having an issue. I'm building window frames using WS2811 strips (11 nodes x 16 nodes). Attached a 9' 18 ga lead on to the 11 node segment, plugged into the E682 and it works fine. Cut the 16 node segment, tested it on the controller and it also works fine. Connect the 2 segments together using 2" wire (wire that came with the strips). When tested only the first segment (11 nodes) work. Checked for continuity across the connection, had 12 volts at the end of the second segment and not sure how to check for data at the connections.

Am I going about this all wrong? Can I not connect segments together in this fashion?


6 Replies
Macrosill
Posts: 9739
(@macrosill)
Member
Joined: 20 years ago

Are you sure you are connecting the second segment in the proper direction? The data comes in one side and out the other. It will not work in reverse. There should be arrows on pixel pcb.


Reply
gassy
Posts: 548
Topic starter
(@gassy)
Honorable Member
Joined: 17 years ago

Arrows going in same direction. If what I'm doing should work, I'll have to play around with connections between the 2 segments. I know that I'm getting voltage across the connection, but not sure if the data is. Is it possible to use a DVOM to check the data signal?


Reply
Macrosill
Posts: 9739
(@macrosill)
Member
Joined: 20 years ago
gassy wrote:..... Is it possible to use a DVOM to check the data signal?

That I do not know.


Reply
Posts: 30
(@randyjb77)
Eminent Member
Joined: 13 years ago

I don't know if you can read data like that but what you could do if the end of the second strip is accessible check for continuity from the data connection wire going in to the first strip and the data wire/connection coming out of the second strip.Or you could check for ohms between the two, you should have almost no resistance if all the connections are good


Reply
Materdaddy
Posts: 2368
(@materdaddy)
Famed Member
Joined: 16 years ago

Are you running a test pattern, or sequencing software? Maybe your software isn't setup to output the proper number of channels.


Reply
gassy
Posts: 548
Topic starter
(@gassy)
Honorable Member
Joined: 17 years ago

Thanks Randy, I did try that earlier and there was no continuity from the data connection between the end of the 1st segment and the end of the 2nd segment, but I didn't know if there should be continuity. So there should be continuity on the data circuit?
Time to go back and check the connections again. Thanks for the help.


Reply
Share: