One of my pixels (pixabulbs) have failed on my house trim. What is my best way to troubleshoot this issue? i have 144 pixels in the string, and the failure happened at pixel 51. The symptom is the beginning of the string works fine, then nothing. Occasionally the second one (52) over from the last working good one (50) turns on, however, the one directly next (51) to the last good one is always off.
My question is... do i replace the first dead one, or the last working one? Is there anyway to tell if the last working one is correctly sending data out, or does the problem lie with the one that is off.
My initial plan is to cut the data line on the in and out of the pixel that is always off (51) and jumper around it. This will let me know if the data being sent to the of the last working one is good. If that doesn't work... i m not sure where to go from there...
All ideas are welcome!
Merry Christmas!!!
Several people automatically cut out the last working (in case it's not transmitting) AND the first not working together, and replace them. It saves you any trouble shooting outside and limits the down time.
I myself had a problem the other day half my tree was working and half not I went too last working one cut wire after it put a spare in and seen if it was working it was so I removed the next one and connected the following too the spare one and it is all working again sometimes it is the one after the last working one and sometimes it is the last working one not sending the data out too the following one
