Pixel String Curren...
 
Notifications
Clear all

Pixel String Current Data???

11 Posts
3 Users
0 Reactions
2,705 Views
Posts: 47
Topic starter
(@navygator)
Trusted Member
Joined: 16 years ago
[#53453]

Has anyone gathered any data available to share on measuring how much current flows through different strings at different intensities?

Example Data Set
Ray WU | WS2811 | 12V | 100 pixel string | 100% = ____ A
Ray WU | WS2811 | 12V | 50 pixel string | 100% = ____A
Ray WU | WS2811 | 12V | 100 pixel string | 90% = ____A
Ray WU | WS2811 | 12V | 50 pixel string | 90% = ____A
.
.
.
.
Ray WU | WS2811 | 12V | 100 pixel string | 20% = ____A
Ray WU | WS2811 | 12V | 50 pixel string | 20% = ____A
.
.

Different vendors, different chips, etc.

I am getting back into the hobby and want to have a small display for next year but want to plan it out so I have a better idea of what to buy so I don't have to keep going back and ordering more stuff.

Rich


10 Replies
Posts: 120
(@superdave)
Estimable Member
Joined: 13 years ago

I believe that it is a big conservative, but you should take a look at: http://spikerlights.com/calcpower.aspx

I'm not sure there has been a large scale comparison of different vendors, although I believe most are using the same ws2811 chip and would be fairly similar. One of the differences I could see were between regulated and non-regulated versions. There is also the 5v vs 12v to consider as well.

Regardless, the link above does have an intensity function.


Reply
Posts: 47
Topic starter
(@navygator)
Trusted Member
Joined: 16 years ago

Can you tell me how I am able to use this website to get what I am looking for? I am not understanding how I get the total current flowing through the string.


Reply
Posts: 186
(@steve123)
Estimable Member
Joined: 7 years ago
superdave wrote:One of the differences I could see were between regulated and non-regulated versions. There is also the 5v vs 12v to consider as well.

The only difference in current consumption comes from strips that have a 12V to 5V buck converter built into them. Otherwise, they all consume approximately 60mA per pixel regardless of "resistor" or "regulated" or "12V" or "5V'. Current consumption is the primary consideration when evaluating your layout and power injection requirements.

With respect to power consumption, 5V pixels always use less power for a given light intensity because they operate at lower voltage. The only caveat is strips that have a buck converter. Unfortunately, there are no pixel strings available with integrated buck converters so that is not an option when using strings unless you make your own custom strings.


Reply
Posts: 186
(@steve123)
Estimable Member
Joined: 7 years ago
NavyGator wrote:Can you tell me how I am able to use this website to get what I am looking for? I am not understanding how I get the total current flowing through the string.

Yeah, that link does not provide the load current. Generally speaking, current = num pixels * 0.06 A/pixel * intensity (percent). However, you should always plan your wiring and injection based on 100% intensity. So, current = num pixels * 0.06 A/pixel.


Reply
Page 1 / 3
Share: