I have attached a picture of the pixel star I am working on. I have attached a picture of it. I'm trying to determine the best method of wiring this thing up to try and make setting up control in V3 as easy as possible. It is a total of 430 pixels, 1290 channels. I intend to control it with an e6804, these are 60pixel/meter 5v strips. There are 10 starburst legs at 24 pixels each, 10 star outline legs at 15 pixels each, and 10 pixel strobe tips at 4 pixels each that you can see in the photo of the cut strips laid out. I plan to run the 5 starburst legs on the right on a e6804 output, the 5 starburst legs on the left on another e6804 output, 5 star outline legs on the right on another e6804 output and 5 star outline legs on the left on the final e6804 output. I would likely add the small pixel "strobe" tips to the star outline outputs to help even things out.
My initial thought is to have the starburst legs laid out so that the data direction on each strip faces outward from the center. I would then inject power at the center point (beginning of each strip) and then connect data and ground from end of strip back to the beginning of the next strip, etc. Or maybe I should just run power/data/ground from the end back to the beginning, from the end to the beginning, etc.
Any input would be greatly appreciated.
Thanks!
-Eric
If it were me, I'd run the outline pixels (150 in total) as one universe on one output. I'd then power inject every 30 pixels. I'd probably set this up as a single element in vix3.
The legs I'd probably do as two outputs as you suggested and power inject at the centre. You can bring the data out wire back to the centre for the next leg by running it through a hole in the board at the end of the strip. I would create a group for the legs, and then within the group create single elements for each leg. Then you can do a spin effect, etc on the legs.
I would add the pixel strobes to the end of those legs as well. You can patch them in quite easily in Vix3 and create the strobes as a separate group/element for sequencing.
The great thing about V3 is that the physical set up and the elements defined for your sequence can be totally different due to the flexibility when patching.
damo1271 wrote:If it were me, I'd run the outline pixels (150 in total) as one universe on one output. I'd then power inject every 30 pixels. I'd probably set this up as a single element in vix3.
The legs I'd probably do as two outputs as you suggested and power inject at the centre. You can bring the data out wire back to the centre for the next leg by running it through a hole in the board at the end of the strip. I would create a group for the legs, and then within the group create single elements for each leg. Then you can do a spin effect, etc on the legs.
I would add the pixel strobes to the end of those legs as well. You can patch them in quite easily in Vix3 and create the strobes as a separate group/element for sequencing.The great thing about V3 is that the physical set up and the elements defined for your sequence can be totally different due to the flexibility when patching.
Thanks for the input. I got everything measured and cut yesterday and then had one of those "if I do it this way then..., if I do it that way....moments" lol
This will be the topper to my new mega tree if I can get it done in the next few days
Sent from my SAMSUNG-SM-G900A using Tapatalk 2
I've been looking at creating stars for the 2015 season and I came across your design. I really like your design and I'll probably model mine after yours. I plan to make mine larger (for a roof) and make the frame out of metal.
That said, can you tell my how you wired it and if you had it to over again, what if anything, would you do it differently?

