Notifications
Clear all

Pixel Power

35 Posts
10 Users
0 Reactions
9,723 Views
Posts: 182
 slug
Topic starter
(@slug)
Reputable Member
Joined: 19 years ago

No, I didn't run the ground along with the data cable. That's an easy fix to try. I'm just using one pair from the CAT5E cable for the data. I already have the ground wire soldered to the pigtail to help with tension on the cable. I just didn't connect it on the board. I will do that when I get home. I hope that's the issue. That will be easy to try. Thanks.


Reply
Posts: 182
 slug
Topic starter
(@slug)
Reputable Member
Joined: 19 years ago

Well, running the ground from the controller to the strings helped the 3001s some. All of them light up, but still getting some erratic behavior. The 2811s are still not good. What I did was connect the ground lead of the pig tail into the 681, and splice the other end into the ground from the waterproof power supply at the string. Is this the proper way to "couple" the ground with the data?

I've built a null pixel for each string tonight that I can just patch into each cable tomorrow morning. Hopefully that will fix my problem. I want to get those two items up and running. They sort of make the show, that's where I've spent at least 60% of my sequencing. Thanks.


Reply
Posts: 503
(@iflights)
Honorable Member
Joined: 14 years ago
slug wrote:it can be rectified

Oh the humor!


Reply
Posts: 182
 slug
Topic starter
(@slug)
Reputable Member
Joined: 19 years ago

Gotta stay optimistic. 🙂


Reply
Posts: 352
(@pmscientist)
Reputable Member
Joined: 16 years ago

20' "should" be ok, but the longer the cable the more important proper termination becomes. Basically all this means is having a source impedance that matches cable impedance. Since you're using CAT5, that's 100 ohms. Voltage drop on the signal wire can become an issue as well, but that's not likely at 20'.

Another thing to keep in mind is how shielding works in CAT5, or any UTP for that matter. The pairs twisted together provide some amount of isolation from other signals. In order to realize this, all signal lines (data and clock) should be paired with a wire connected to ground in single ended signaling (this is the type in use here). For example, if the signal line is solid green, striped green should be connected to ground. RS485 that timon mentions uses differential signaling, which has definite advantages, but shouldn't be strictly necessary over 20'.

You're correct to tie the grounds of the two supplies together.


Reply
Page 2 / 7
Share: