Notifications
Clear all

Pixel Power

35 Posts
10 Users
0 Reactions
9,722 Views
Posts: 182
 slug
Topic starter
(@slug)
Reputable Member
Joined: 19 years ago
[#29149]

So, this year I tried something new, and it didn't go so well. But, it can be rectified, if I'm wrong.

I have some WS2811s and TLS3001s out in the yard. I decided I would put a waterproof 5v supply out in the yard and just run the data from the 681. It seemed to work fine during testing with just a 10 foot cable, using just data from the controller. But, now at 20 feet, I'm getting a flickering across the WS2811s and sporadic pixels going on and off with the 3001s. This is a new power supply and could be putting out crappy voltage, but I'm wondering if I hit the threshold on distance without a null pixel. I've got the GECEs going to the same controller with 30 foot runs and no problems, but I'm running the power from the controller.


34 Replies
Posts: 2128
(@livermore-dad)
Famed Member
Joined: 16 years ago

Not sharing the ground with the controller and the remote Powersupply? Can you run just a single ground cable?


Reply
Posts: 512
(@habbosrus)
Honorable Member
Joined: 14 years ago

You need to run ground along with data and at 20', you will probably need a null pixel. What size is your cable? I found using a larger cable extended my data a little. I have used larger cable and have one element approximately 8.5 metres from the controller without any problems.


Reply
jchuchla
Posts: 8698
(@jchuchla)
Illustrious Member
Joined: 15 years ago

using the default resistor packs on the 681? may want to try a lower resistance pack. I had trouble with lead wire extension on 2811s. I had to lower the r-pack value to 100 ohm and I got 40' without a null pixel.

bonding grounds is also a must.


Reply
timon
Posts: 2149
(@timon)
Noble Member
Joined: 16 years ago

Once you get into split supplies I personally think going with RS485 extenders is the better way to go. I going to test some isolated pixels extenders soon which will remove any issues with ground currents and loops.


Reply
Page 1 / 7
Share: