Pixel power questio...
 
Notifications
Clear all

Pixel power question

9 Posts
5 Users
0 Reactions
3,149 Views
Posts: 4092
(@skunberg)
Famed Member
Joined: 18 years ago

I put my E682 in the middle of the 2 strings and reverse one string. So to the sequence software it's one long string and being run in the middle I don't have any power problem.


Reply
Posts: 215
Topic starter
(@reelpilot)
Reputable Member
Joined: 12 years ago

Flipping the string on the controller doesn't address my problem because flipping would require even longer wire runs to the start of the string.

Using MrSmoofy's example above, say I have a 50 pixel string that runs left to right. On the left side at pixel 1 the distance from my controller is 35'. On the right side at pixel 50 the distance from the controller is 53'. If I were to flip the string and physically locate pixel 1 on the right, I would have a longer run from the controller. Due to the nature of my layout it just so happens that I need to power inject another string in the same area on the right side near pixel 50. Therefore my thought was to locate a power supply on the right side and use it for my power injection and to power this 50 pixel string from its end.

In essence I'm power injecting a 50 pixel string, but from the end of the string only. As I mentioned in a previous post there will be a need for 1 null pixel and I'll power that from the controller and terminate the V+ between the null pixel and pixel 1. As I'm writing about this, the more I realize that all I'm doing is wiring this pixel sting the way anybody would do power injection with multiple power supplies. The only difference is most power injection is done on longer strings. I'm just doing it on a smaller string that wouldn't otherwise need to be powered from the end if it wasn't for my physical layout.


Reply
Posts: 1344
(@mrsmoofy)
Noble Member
Joined: 12 years ago

Pictures are worth a thousand words in this case 🙂


Reply
Posts: 4092
(@skunberg)
Famed Member
Joined: 18 years ago

You could buy one or two E6804 controllers for the odd spots.


Reply
Page 2 / 2
Share: