First light show and things are not working as I thought they would. I think the problem is power but I want to have the community double check my math and assumptions
I am running 600 12V pixiels. I am calculating that each pixel is using .06amps for a total of 60 amps being outputted. I have a 360 Watt power supply rated for 30A. I am pretty sure that is my first problem. Assuming that my calculation are right, I would need to tie another 30A power supply to my show or get a larger power supply??
I originally got 12V power supplies because of ability to do longer runs with no power injection but it seems like I am going to need many power supplies as my show expands and that just doesn't feel right.
0.06*600=36 amps. At 12 volts that's 432 watts. So yes, you need another power supply.
ezellner wrote:0.06*600=36 amps. At 12 volts that's 432 watts. So yes, you need another power supply.
Is it recommended to tie 2 power supplies together or will power injection have the same effect?
Do most people get larger power supplies or just run banks of smaller ones?
Sent from my SM-G930V using Tapatalk
nayrma wrote:Is it recommended to tie 2 power supplies together or will power injection have the same effect?
These are sort of unrelated topics - you can power inject from one or multiple power supplies; however, the power supply will only output what it can output whether you have one power injection connection or 10. In other words a 350w power supply can never output more than 350w and in reality staying at 80% of that number is a good practice. If your overall power requirements dictate additional power supplies (based on the size of supplies you use) then the basic math calculations will dictate the number of supplies needed.
nayrma wrote:Do most people get larger power supplies or just run banks of smaller ones?
This is a "personal" question as there are many ways to handle this based on personal preference. For me I have standardized on 12v, 29a power supplies so when I need more power I pull one off the shelf and keep on rolling. I think folks on the site probably do this many different ways based on how they have built their shows.
I have settled on two power supplies 5V 60A and 12v 30A. Even if I don't fill the supply at a given location, that is what I use. I keep three spares of each and swapping them is easy since I mount them in the enclosure using velcro. 8 Screw connections and I am done.
