Revived Fried 5v Pi...
 
Notifications
Clear all

Revived Fried 5v Pixel Strips

1 Posts
1 Users
0 Reactions
1,130 Views
Posts: 113
Topic starter
(@randyr505)
Estimable Member
Joined: 18 years ago
[#47426]

I was going through my pixel strips (5 @ 5m 30pcs/m) and realized I must have fried 3 of them last year with my 12v power supply by mistake. Just a light or two would come on, usually light blue or white. I used some raspberry pi square end male to male cables. I taped the 3 cables together which provided perfect spacing for my 3 pin rgb pixel strips. I connected the other end to my DMX-SPI decoder I used for testing. I quickly realized that a random pixel would work perfect (these may fail later but for now they are good). The process is to check each connector cutting as few as possible. You can even check without cutting any as seen in the attached pic.

One the first strip I tested I only saved about the last 30 pixels (plus a few random pixels throughout the strip). On the other two I only lost about 30 each (out of 150). All in all I saved about 2/3 of my strips, much better than 100% loss that I first suspected.

Hope this helps someone. Don't forget to make sure you are checking in the proper direction notated by the arrow on the strip.

20171202 140833

Randy


Share: