Notifications
Clear all

Pixel equipment

15 Posts
8 Users
0 Reactions
4,331 Views
Posts: 928
(@arw01)
Noble Member
Joined: 13 years ago

$40.00 and distances to first pixel can be issues with a central location vs being able to put the controllers close. One of the reasons I really like the pixelnet family of products, a lot of flexibility that way.


Reply
Posts: 213
(@aaron1)
Estimable Member
Joined: 16 years ago
Robo wrote:Fused outputs, screw terminal connections...

The e6804 and e682 both have those.


Reply
Posts: 4092
(@skunberg)
Famed Member
Joined: 18 years ago

E682 can do 2 voltages and has 4 outputs per cluster. Makes it a little more versatile for the future. Unless you're building it into the prop.

Sent from my SCH-I545 using Tapatalk


Reply
Posts: 352
(@pmscientist)
Reputable Member
Joined: 16 years ago

Just to clarify, the 6804 can do 12V and 5V, it just can't run both voltages through the controller board at the same time. You could still use a second external supply of different voltage if you tie the grounds together. It's a less convenient setup for dual voltage, but cheaper.

Besides capacity/versatility, the 682 has on board level shifters so you get 5V on the data lines instead of 3.3, and provisions for termination resistors. Those features help with distance to the first pixel and overall signal integrity. For full details, the device docs are probably the best source of complete information.


Reply
Posts: 848
(@tfischer)
Prominent Member
Joined: 17 years ago

682 also has better output protection via driver chips and also pluggable resistor networks. E6804 is driven directly from the Propeller, and is somewhat easy to blow out an output if a stray voltage gets placed on the wrong terminal.

Not knocking the 6804 by any stretch... I just bought one actually 😉 It's just I would prefer a smaller number of controllers to a larger number, everything else being equal, and suggested a single 682 to replace 2 (if not all 3) of the 6804's.


Reply
Page 3 / 3
Share: