Notifications
Clear all

Pixel equipment

15 Posts
8 Users
0 Reactions
4,332 Views
howards9
Posts: 155
Topic starter
(@howards9)
Estimable Member
Joined: 15 years ago

QUOTE=tfischer;315833]Have you considered using a 682 (which has more features and better power handling) in place of 2 or all 3 of these?

A little. Trying to centrally locate and running wires had kept me away from it. But, taking a look at the pic, I guess I could locate a 682 on the roof where the dormer is. Two sets of wires could run down next to the right side of the garage. One set for garage/left perimeter and another set doing the same and crossing the small sidewalk to the right perimeter.

What were you thinking?[


Reply
howards9
Posts: 155
Topic starter
(@howards9)
Estimable Member
Joined: 15 years ago
aaron1 wrote:Your controller plan will definitely work. One e6804 for each section will easily control the number of pixels you're talking about. From the lengths of your strings, however, you may want to consider the ability to power from both ends. It may or may not be necessary, but per my post above, I could see a substantial change in brightness between pixel 1 and 150. You have a couple options. Either get a power supply for both ends of the string or run a high-ish gauge cord from the location of the single power supply to the "far" end of the string. I'm going with the latter, using either 16ga or 14 ga wire. One way to help this, especially for your roof section, where my math tells me you'll be using about 125 pixels or so, is to put the controller in the center of the string. This will make each string half as long, without making your setup any more complicated. This might mean you won't need the power at both ends, but it's tough to say for sure.

Your line of thinking is what mine is. Trying to wrap my head around the possibilities.


Reply
Posts: 213
(@aaron1)
Estimable Member
Joined: 16 years ago
howards9 wrote:QUOTE=tfischer;315833]Have you considered using a 682 (which has more features and better power handling) in place of 2 or all 3 of these?

A little. Trying to centrally locate and running wires had kept me away from it. But, taking a look at the pic, I guess I could locate a 682 on the roof where the dormer is. Two sets of wires could run down next to the right side of the garage. One set for garage/left perimeter and another set doing the same and crossing the small sidewalk to the right perimeter.

What were you thinking?[

Depending on the length of run between the e682 and the location in your yard, you would likely need to add one or more null pixels between the controller and the first "real" pixel. Not difficult, but it's one more thing to think about in this implementation.


Reply
rjchu
Posts: 1191
(@rjchu)
Noble Member
Joined: 17 years ago
tfischer wrote:Have you considered using a 682 (which has more features and better power handling) in place of 2 or all 3 of these?

Aside from more outputs, I'm not aware of any additional features on the e682 vs an e6804. Can you elaborate?

Thanks,

-joni-


Reply
Robo
Posts: 1494
 Robo
(@robo)
Noble Member
Joined: 14 years ago

Fused outputs, screw terminal connections...


Reply
Page 2 / 3
Share: