Notifications
Clear all

Pixel equipment

15 Posts
8 Users
0 Reactions
4,329 Views
howards9
Posts: 155
Topic starter
(@howards9)
Estimable Member
Joined: 15 years ago
[#30379]

Looking to add Pixabulbs (PBs from here on) next year and looking for insight from those with experience with pixels. I have included a pic of my house for reference.

I will be adding PBs in place of all my C7 retrofit LEDs which are the roofline, garage, and yard perimeters. Below is what I think I need but it might be an overkill since I do not know the limitations of the distances between the 3 different locations I need (see pic).

What I have come with is, I will need:
(1) E6804, (1) power supply ---> for all roof PBs
(1) E6804, (1) power supply ---> for left yard perimeter PBs, and possibly along with garage PBs
(1) E6804, (1) power supply ---> for right yard perimeter PBs

Thoughts, suggestions, advice?

-Shane

my xmas house

14 Replies
Posts: 213
(@aaron1)
Estimable Member
Joined: 16 years ago

What PB spacing are you considering? And what are the lengths of the 3 "sections" you describe above. You may need a couple power injection points, depending on the string length and location of the controllers.

I did some recent testing with some PBs I ordered last year. 4" spacing. With 150 bulbs, for example, color shift was negligible, at best (my wife and I couldn't detect any), but brightness at the end of the 150-bulb string was noticeably less. So, I'm planning to still use the 150-bulb length in my setup this year, but I'll be applying power to both ends of the string.


Reply
howards9
Posts: 155
Topic starter
(@howards9)
Estimable Member
Joined: 15 years ago

I'm looking at 10" spacing. Roof section is 104', Left perimeter w/ garage is 85', and Right perimeter is 63'.


Reply
Posts: 213
(@aaron1)
Estimable Member
Joined: 16 years ago

Your controller plan will definitely work. One e6804 for each section will easily control the number of pixels you're talking about. From the lengths of your strings, however, you may want to consider the ability to power from both ends. It may or may not be necessary, but per my post above, I could see a substantial change in brightness between pixel 1 and 150. You have a couple options. Either get a power supply for both ends of the string or run a high-ish gauge cord from the location of the single power supply to the "far" end of the string. I'm going with the latter, using either 16ga or 14 ga wire. One way to help this, especially for your roof section, where my math tells me you'll be using about 125 pixels or so, is to put the controller in the center of the string. This will make each string half as long, without making your setup any more complicated. This might mean you won't need the power at both ends, but it's tough to say for sure.


Reply
Posts: 848
(@tfischer)
Prominent Member
Joined: 17 years ago

Have you considered using a 682 (which has more features and better power handling) in place of 2 or all 3 of these?


Reply
Page 1 / 3
Share: