Pixel Delay (a.k.a....
 
Notifications
Clear all

Pixel Delay (a.k.a. Pixel Data Splitter)

13 Posts
7 Users
0 Reactions
7,446 Views
RobG
Posts: 1255
 RobG
Topic starter
(@robg)
Noble Member
Joined: 14 years ago
[#51909]

After many months, I finally have time and energy to finish this project.

I have 3 new boards I call Pixel Delay (a.k.a. Pixel Data Splitter.)
1 channel board - which in size is similar to my buffer/driver board, and is designed to be used with T-splitter, weather sealed between 2 cables.
3 channel board - slightly bigger, but can also be weather sealed.
6 channel board - a bit larger, must be installed in a case.
(note that 1, 3, 6 is the number of "delayed" channels, so the total number of branches is 2, 4, 7.)
All outputs are buffered (so you basically have buffer/line driver,) and the 3 and 6 channel versions have a buffered output of the input signal.
1 and 3 channel boards can be sealed, but they can still be programmed. You use magnet to put the board in programming mode. 6 channel version has a mechanical switch.
1 channel board can be programmed by sending exact number of pixels to be delayed, 3 and 6 channel boards have to be programmed using either Terminal (PC) or a small programmer which I will make. Pictured boards are prototypes, final boards will be slightly different.

Any feedback is appreciated.

IMG 9179

12 Replies
Posts: 602
Guest
(@bwinter)
Member
Joined: 10 years ago

Can the “delay” on each channel be set discretely?


Reply
RobG
Posts: 1255
 RobG
Topic starter
(@robg)
Noble Member
Joined: 14 years ago

Yes, they are separate channels


Reply
Barnabybear
Posts: 1583
(@barnabybear)
Noble Member
Joined: 15 years ago

Hi, looking good Ron as always. These should be in every ones toolbox for next year.


Reply
Posts: 39
(@robomello)
Eminent Member
Joined: 12 years ago

I am sorry my ignorance, but where would I use this board?

Sent from my iPhone using Tapatalk


Reply
Page 1 / 3
Share: