Falcon F16V3 Pixel ...
 
Notifications
Clear all

Falcon F16V3 Pixel Controller

4 Posts
2 Users
0 Reactions
1,845 Views
RGB_Mixer
Posts: 270
Topic starter
(@rgb-mixer)
Reputable Member
Joined: 12 years ago
[#51915]

I hope someone has an answer for this goofy issue.

Falcon F16V3 Pixel Controller I upgraded the firmware - OK (some issues but got it running) ... DING DING DING!!! BAD answer!!

I re-flashed the firmware 5 times - same result.

Now the controller does this ... (see video) (my FB Page ... Our House 1374) DANG ... cannot upload 4 sec video to FB!

String on the LEFT is working properly and at the right update speed on a PixLite 16.
String on the RIGHT is NOT working properly - almost like it was set @ 250ms update and occasionally skips a frame or two.

I lost all GECE support - the expansion module (Extended remotes or DX) refuses to work - it does not send 900 channels properly (a string of 300 and it is blank in the middle for about 50 pixels)

I cannot find the OLDER firmware that DID work properly.

If anyone knows where I can find the older firmware - MUCH APPRECIATED!!

thanks!


3 Replies
Posts: 1168
(@keith-r)
Noble Member
Joined: 19 years ago

Why not contact David? He is the best when it comes to customer support for his own products.


Reply
RGB_Mixer
Posts: 270
Topic starter
(@rgb-mixer)
Reputable Member
Joined: 12 years ago

Fixed it ... still dunno how it happened. MASTER RESET - something I tried before but tried again.

Now it is working as intended. Apparently it did not like the NETWORK addressing.

It is updating the ws2812 pixels ... need to try it on the DX and the GECE props .. that would be the acid test.


Reply
RGB_Mixer
Posts: 270
Topic starter
(@rgb-mixer)
Reputable Member
Joined: 12 years ago

David forwarded a new firmware file ... fixed the issue with GECE pixels not working.

running some simple tests after the new firmware, DA_E131 can exercise the controller @ 20ms updates. GECE pixels cannot keep up but try. The WS2811 pixels just buzzed alone like it was a sunny day ... This is GOOD.

I was informed the GECE on the DX EXPANSION BOARD *WILL* slow the entire system down. No matter which pixel you use, because the GECE pixels are so slow, it slows down everything. This I did not know. Seemed to work OK last year - dunno. Mostly static so rarely updates but slowing down the WS2812 pixels? NOT GOOD. Work-around ... figured it out.

This is probably the last year for my GECE pixels - looking at alternatives.

I have an E682 and it handles the GECE pixels at full tilt (20ms) - my first pixels were GECE and my first controller was a E6804 and then the E682 :biggrin2:

The E6804 needs a new Propeller ... apparently something caused all the outputs to blow out. Waiting on replacements to arrive ... dam, dam, dam! USPS is slow as ....


Reply
Share: