Pixel Controller Th...
 
Notifications
Clear all

Pixel Controller Thread

23 Posts
11 Users
0 Reactions
7,999 Views
dpitts
Posts: 1020
(@dpitts)
Noble Member
Joined: 16 years ago
JHinkle wrote:Thanks David -- what the fastest pixel type you support?

Joe

I believe the 2801 four wire pixels are most likely the fastest. I run them at 2Mbps. Although the refresh rate could be increased from 40Hz if less pixels per port was selected and a faster pixels were attached, I decided to limit the refresh rate using the slowest pixel and 680 pixels as count. This reduced the complexity of having pixel ports running asynchronous from each other. When you have 32 possible ports and all can be a different pixel type I needed to add some simplicity to the design. 🙂


Reply
Posts: 8517
(@angus40)
Illustrious Member
Joined: 15 years ago
dpitts wrote:I believe the 2801 four wire pixels are most likely the fastest. I run them at 2Mbps. Although the refresh rate could be increased from 40Hz if less pixels per port was selected and a faster pixels were attached, I decided to limit the refresh rate using the slowest pixel and 680 pixels as count. This reduced the complexity of having pixel ports running asynchronous from each other. When you have 32 possible ports and all can be a different pixel type I needed to add some simplicity to the design. 🙂

Could this controller be use in multicast for the 680 per port or does it require unicast ?
I have a matrix that is just over 4k pixels and was thinking this controller could be a solution .
Thanks


Reply
dpitts
Posts: 1020
(@dpitts)
Noble Member
Joined: 16 years ago

Either Multicast or Unicast. In fact it just receives either right out of the box. I may put a "Do not Receive Multicast" option in later release of firmware.


Reply
Page 3 / 3
Share: