Pixel acting strang...
 
Notifications
Clear all

Pixel acting strangely.....?

3 Posts
2 Users
0 Reactions
1,346 Views
Posts: 1763
Topic starter
(@santacarl)
Noble Member
Joined: 19 years ago
[#39802]

UPDATE: What are the odds? I went back and installed roughly half a new string to cover past pixels 17 & 18..... I brought the old string into the house and put it on a spare controller....and BAM, pixel 18 was dead when I first turned it on.....powered down....powered back up and it began the blue glow thingy.....with the following pixels out....

So a brand spanking new pixel that worked in a pre test before installation failed once on the tree.....and in the exact same quirky way..... This could make you want to go hit the egg nog......HA....

Oh well......I think I solved the mystery.

Hey All,

I have a pixel (2811/5050) string that has me stumped. When I first fire up for the night everything works fine but then a few minutes later this string starts acting up. The string is 60 pixels long and pixel #18 turns/glows blue (and remains on when it should be off) and those pixels downline (after pixel 18) turn different colors (some red, some green, some blue) and stay on or are completely off. You can move the wires going into pixel 18 and it seems to correct it for a bit but it goes rogue again.

Before pixel 18 started this I had pixel #17 act this same way and I replaced it(17).....things worked normally for a couple of nights and then pixel 18 started doing this exact same thing.

I replaced pixel 18 with a new pixel and it didn't make any difference....it is still acting up. So pixels 17 and 18 are new.

I plugged in a different string in to the controller and it works normally and this strange acting up doesn't happen so I know it's not the controller.

So here's a question. Can a pixel downline some place cause this? I've never seen that happen where a pixel affects a pixel before it.....

Any other thoughts are welcome....I'm tired of chasing this phantom..... I hate to take down a 20 foot PMT to replace 1 string....but it sure would be nice if I could figure out and replace a single pixel instead....

Thanks for any help....

SC


2 Replies
Posts: 459
(@shockwave)
Reputable Member
Joined: 15 years ago

I personally accuse the pixel before the dead one. If a pixels data out dies then the next pixel and all after will be messed up. It may display garbage or nothing, depending how the data pin in the preceding pixel died.


Reply
Posts: 1763
Topic starter
(@santacarl)
Noble Member
Joined: 19 years ago
Shockwave wrote:I personally accuse the pixel before the dead one. If a pixels data out dies then the next pixel and all after will be messed up. It may display garbage or nothing, depending how the data pin in the preceding pixel died.

Shock....you might have something there.... I had already replaced the one before a couple of days ago.... Looks like I had 2 in a row that were bad...

I have seen both scenarios...sometime the one before and sometime the one acting up..... trial and error troubleshooting is the cure I guess.


Reply
Share: