Ordering custom 5vd...
 
Notifications
Clear all

Ordering custom 5vdc 2811 icicle

24 Posts
10 Users
0 Reactions
7,647 Views
Posts: 53
Topic starter
(@modderhut)
Trusted Member
Joined: 15 years ago
[#38014]

Hello,

I'm trying to get pixel icicles as in below config. Have an open request at Ray and my usual Chinese supplier on Ali-express. As I could not find them in any shop I was wondering if there was more interest them so I can tell supplier to put them on stock, or if anyone already ordered these or sees a problem with this config,

I'm not organizing a group buy, just looking for bulk price as I only need 12 sets myself.

icicle nodes

the sets are probable going to be 40 led's in 4+5+6+5 +4+5+6+5 config


23 Replies
Posts: 6728
(@p-short)
Illustrious Member
Joined: 19 years ago
modderhut wrote:Hello,

I'm trying to get pixel icicles as in below config. Have an open request at Ray and my usual Chinese supplier on Ali-express. As I could not find them in any shop I was wondering if there was more interest them so I can tell supplier to put them on stock, or if anyone already ordered these or sees a problem with this config,

I'm not organizing a group buy, just looking for bulk price as I only need 12 sets myself.

the sets are probable going to be 40 led's in 4+5+6+5 +4+5+6+5 config

That would be a group buy if you collect money up-front.


Reply
Posts: 53
Topic starter
(@modderhut)
Trusted Member
Joined: 15 years ago

Hi Phil, I'm not collecting money, just seeing if more people where looking for this and ask them to contact vendor themselves, I can then ask vendor to wait till he has more orders in and hopefully drop the price for everyone a bit. As I use 5v I don't expect it's worth the trouble of a group buy. And I'm in the Netherlands that would be hard. Thx.


Reply
Posts: 167
(@bigbenamerika)
Estimable Member
Joined: 13 years ago

That does Sound interesting!
Lets see what Ray wants for it. But I would think about it if the money is right.


Reply
Posts: 6728
(@p-short)
Illustrious Member
Joined: 19 years ago

I think that you should specify the wire gauge if you haven't done so already. I assume that you're going to do power injection at least every 40 pixels (every eight 'icicles'). The lengths of wire between the 'icicles' is going to add up, so I think that you should go for fairly beefy wiring.


Reply
Page 1 / 5
Share: