Hey guys, Total noob this year but learning all this has been fun, although challenging at times. So I am hooking up my pixels to my SanDevices e682 and have a question about the power cables. Is it common to have two sets of power cables coming out of the input end? I'm guessing the 2nd set of cables on the input is for external power if your controller doesn't supply power on the same connector as the data. The e682 of course can power internally through the connector ports so I am guessing that this second set of power leads can be terminated/taped if not in use?
Thanks in advance!
I would assume you are talking about pixel strips as this is where I have seen the extra wires. The 2 extra wires, no data, are for power injection if you need it but on my strips I just cut the 2 extra wires off as the e682 powered them and I did not need any additional power injection on my strips.
That is correct. If you're only sending data from your E682, then the other side doesn't need power. That secondary power input is for when you're using dual voltages AND using the controller as a first source of power for the pixels.
Perfect, That makes sense. Just good to have as much input as possible. Tonight I finally got the bugs worked out and actually got vixen 3 to talk to the lights for the first time! Exciting stuff!
I need to correct my statement...you use both sides when you're sending power to pixels, dual voltage or not. Only one side powers the board though. Result is the same in your situation.
Sent from my LG-H811 using Tapatalk
