I am starting to build and test props, controllers, etc. I have one area that is giving me trouble and I would like some help. I am using PixLite 4. All pixels are 2811 12V. Controller PixLite4. Everything works well until I get to my windows. In this instance, I have two windows each has 70 pixels. The first window works fine, but the 2nd window will blink like there is a data issue. Both windows are on the same output and are approx 10 feet apart. I can get things to work well if I test in the shop and I connect the 2nd window with a 5ft cord. Any longer and I get issues. My windows are the only props where I have 10-15ft between each other. I can run 40ft to the first window with no problem, but if my connection between the first and second window is more than 5ft, things just don't work.
So, is this "normal"? Right now my cable is 16ga speaker wire, which has worked well so far. Should I try cat5 cable, or is there a need for null pixels? Just curious why things work well up to the first window, but then gets messed up from there.
Any help would be appreciated. Hopefully I included all info, if not, let me know.
James
Do you have power injection between 1st and 2nd window or at the end of 2nd? 140 pixels with 5-10' gap may be stretching it without power injection.
Are you running power from the Pixlite 4 or directly to pixels?
Power injection doesn't help this issue, I've tried with and without. This really looks like a data issue.
I'm running power from the controller.
When I tried power injection I did it at the end and between the two windows.
Is there any crossing of data with v- or v+. I had an issue last year that sounds similar to yours and I first added power which I thought helped but I still noticed some erratic blinking. I found a small connection between v- and data in my cable. I made a new cable and saw something very similar again. Took me a while to work out the waterproof connector also had a fault as well. If I moved it one way, it was fine. If I moved it slightly, I saw the erratic blinking.
Trying to find the fault can drive you crazy with trial and error.
Sounds like the issue I had. It came down to a data issue and having too much wire between elements. I was able to get it down to about 6-7' and the problem went away.
On Facebook in the Introduction to RGB on July 25 there is a post about it.
I contacted Advatek for help and we were able to narrow down that it was too much distance from one set of lights to the next.
I went in on the group by and have some uAmps on the way.
Travis
Sent from my iPhone using Tapatalk
