Old E681 Controller...
 
Notifications
Clear all

Old E681 Controller problems

11 Posts
3 Users
0 Reactions
3,249 Views
Braveit1
Posts: 577
Topic starter
(@braveit1)
Honorable Member
Joined: 19 years ago
[#44115]

I dug an old E681 controller (non upgraded) out and wanted to play with it now that the lights are up. It had the original firmware installed (v2.021) and I wanted to install a newer firmware to use the Ws2811 pixels. I know I can't install the newest firmware because it still has the older wiznet nic on it but I also know there is a one I can install. So I went to Sandevices web page and looked at the documentation. I found the 2.049-01 firmware for the E681 and fired up the configuration page. Using the Python app and renaming the firmware file to firmware.eepron like the instructions said, I executed the script and entered the command to update. The script started running. I let it run for about 3 hours and the board is still flashing the red and green lights. Now the network connection keeps cutting out so I cannot reconnect to the configuration page. Also the Pixel power 1-2 light is no longer lit but the other yellow lights are still on.
What can I do to get it back?


10 Replies
jchuchla
Posts: 8698
(@jchuchla)
Illustrious Member
Joined: 15 years ago

It sounds like you're going to need to load it via a prop plug. This is a serial upload method that uses the prop tool software to program the board directly instead of having the board program itself.


Reply
Braveit1
Posts: 577
Topic starter
(@braveit1)
Honorable Member
Joined: 19 years ago

I thought that may be the case. I don't have a prop plug. 🙁


Reply
jchuchla
Posts: 8698
(@jchuchla)
Illustrious Member
Joined: 15 years ago

do you have a USB-TTL Serial adapter of any kind? Perhaps one you used for programming a komby board or ESP or something along those lines? You can use that by using jumper wires to the proper pinout.


Reply
Braveit1
Posts: 577
Topic starter
(@braveit1)
Honorable Member
Joined: 19 years ago

I have a usb-TTL serial adapter.


Reply
Page 1 / 3
Share: