cheap controller fo...
 
Notifications
Clear all

cheap controller for bench testing lights

22 Posts
15 Users
0 Reactions
6,029 Views
Posts: 28
Topic starter
(@vipersinu2)
Eminent Member
Joined: 10 years ago
[#44121]

is there a cheap controller that I can hook up to computer for bench testing lights from xlights.


21 Replies
Posts: 86
(@markrvp)
Estimable Member
Joined: 19 years ago

If it's a requirement to send a signal out of xLights to see if the lights respond to the programming, then a Raspberry Pi running Falcon Pi Player would probably be cheapest. You can either pull signal directly off the GPIO pin or purchase one of the Pi Hat/Cap's that are available.

If all you want to do is verify the lights work, then something like this would work nicely: http://www.holidaycoro.com/DMX-to-SPI-Smart-Pixel-Decoder-Controller-p/614.htm You can also make that work as a controller, but you need something to output DMX512 from your computer.


Reply
Posts: 28
Topic starter
(@vipersinu2)
Eminent Member
Joined: 10 years ago

I would like a controller that I can hook up to xlights via PC. To test led patterns. I have strips mounted on my soffits, but there are so many different patterns and combinations. I would like to test before I commit to xlights and load it to the FPP. I find it hard to get the led strips to look cool.


Reply
dirknerkle
Posts: 10310
(@dirknerkle)
Illustrious Member
Joined: 18 years ago

With a Renzilla you can test almost anything simultaneously - AC lights with SSRs, LED strings with DC SSRs, DC strip lights with the LSD adapter, servos with the servo adapter, and even pixels with the PX-1 adapter. It's not as cheap as a PI, but then again, once configured, you'd just plug the lights into the appropriate adapter and fire it up -- nothing else to configure... it's the ultimate test bench controller...

renzilla adapters

Reply
Posts: 28
Topic starter
(@vipersinu2)
Eminent Member
Joined: 10 years ago

I looked on line. Does this need to be built? I can find is a board.


Reply
Page 1 / 5
Share: