Nutcracker set up
 
Notifications
Clear all

Nutcracker set up

10 Posts
3 Users
0 Reactions
4,189 Views
THurrle
Posts: 1211
Topic starter
(@thurrle)
Noble Member
Joined: 17 years ago
[#30490]

I have done my set up and am just asking if this looks correct.Here is how I have the controllers set up for the universes.
Universes 1-4 E682 pixel tree
Universes 5-6 E682 #2 pixel tree
Universe 7 E682 # 2 three pixel arches each arch 50 pixels
Universe 8 E1.31 bridge set up for 255 renard channels using xbee radios w/RenW board
Universe 9 E 1.31 bridge set up for 8 renard channels using xbee radios w/RenW board
Will have to get another e1.31 bridge. Sold mine because I didn't think I would need it but am Going to use the Raspberry PI so I will have to have it for my renard sutff
See Attached.
Thanks for the input.
Terry

e1.31

9 Replies
Posts: 213
(@aaron1)
Estimable Member
Joined: 16 years ago

How many pixels on your megatree? Looks like 1008 pixels? If yes, then the network setup appears to be good. You'll want to make sure your models line up with the network setup if you intend to drive your lights from xlights. For example, your first arch will begin at channel 3025.


Reply
THurrle
Posts: 1211
Topic starter
(@thurrle)
Noble Member
Joined: 17 years ago
aaron1 wrote:How many pixels on your megatree? Looks like 1008 pixels? If yes, then the network setup appears to be good. You'll want to make sure your models line up with the network setup if you intend to drive your lights from xlights. For example, your first arch will begin at channel 3025.

That is correct. I have 24 strings of 42 pixels each. COmes out to the height of my old mega tree pole. Thanks you for the reply
Terry


Reply
Electrified3
Posts: 716
(@electrified3)
Prominent Member
Joined: 13 years ago

Terry, do yourself a favour and just set it to 12 universes 510 channels so you assign all of your capability of the controller running unicast.

Now, put up a screenshot of your E682 controller set up as well, need that to see if it aligns up. That set up is more important for your pixel layout of how many pixels per output to your displays.

Once you get past that the next key will be your model set up in nutcracker, but keep it simple, set max channels for your nutcracker input device (your screenshot), then be sure to correctly set up your E682 outputs then we can work on models which is where we will define your pixel arrangement on your displays.

Post your screenshot of your nutcracker set up when done and your E682 set up and we can go from there.

If you have any questions just shout.


Reply
Electrified3
Posts: 716
(@electrified3)
Prominent Member
Joined: 13 years ago

Also looking at your Renard stuff, don't buy that bridge just yet, work it out slowly first and we will get there.


Reply
Page 1 / 2
Share: