Notifications
Clear all

Null pixel help

10 Posts
6 Users
0 Reactions
2,945 Views
TazChaLet
Posts: 3042
(@tazchalet)
Famed Member
Joined: 13 years ago

I have a friend using cat cable for the data/gnd and he is going 47' but as for power he is running normal wire for that trying too get power over the cat cable wasn't working right he would get flickering in pixels once he ran power wire everything worked right no null pixels inline


Reply
Posts: 28
Topic starter
(@tcraft29)
Eminent Member
Joined: 13 years ago

I have both cat5 and cat6 cable so I will do some experimentation tomorrow and see what I can get to work. This is the last thing I have to get done before everything is fully hooked up and running.


Reply
Wolfie
Posts: 2225
(@wolfie)
Noble Member
Joined: 11 years ago

To answer your question, yes, the null pixel needs power. But, if its a true null pixel (meaning no LED) then the power consumption is extremely low. Its simply regenerating the signal.

I use a lot of cat5 and get distances 40-50' without null pixels.


Reply
Posts: 2
(@hsiboy)
New Member
Joined: 12 years ago

On long runs i've seen flicker because the voltage was too high rather than low. I had increased the voltage to 5.5v at the start of the run, and measuring at the end showed 5.3v
Dropping the voltage at the start of the run to 5v gave me 4.7v at the end and no flicker.

Sent from my LG-H815 using Tapatalk


Reply
Posts: 28
Topic starter
(@tcraft29)
Eminent Member
Joined: 13 years ago

I used cat5 for my 3 long runs and everything worked. Thanks for all the help everyone.


Reply
Page 2 / 2
Share: