Notifications
Clear all

Null pixel help

10 Posts
6 Users
0 Reactions
2,946 Views
Posts: 28
Topic starter
(@tcraft29)
Eminent Member
Joined: 13 years ago
[#43301]

I am using a falcon controller and have three runs that are a little over 40 feet from the controller. I knew this was too long but wanted to try and connect at this length anyway. I get full power but I do get a little flicker on the entire string.

I figure I need to place a null pixel on the run but do I connect data only to the pixel or do I need to run power through it too?

Any suggestions are appreciated.


9 Replies
rstehle
Posts: 4348
(@rstehle)
Illustrious Member
Joined: 19 years ago
tcraft29 wrote:I am using a falcon controller and have three runs that are a little over 40 feet from the controller. I knew this was too long but wanted to try and connect at this length anyway. I get full power but I do get a little flicker on the entire string.

I figure I need to place a null pixel on the run but do I connect data only to the pixel or do I need to run power through it too?

Any suggestions are appreciated.

For the Pixel to operate and boost the signal, you need to connect all of the wires to it. Another thing you might try is using Cat5 or Cat6 cable. Use 3 strands for V+, 3 for V- and one of the Orange wires (only) for Data.


Reply
Posts: 28
Topic starter
(@tcraft29)
Eminent Member
Joined: 13 years ago

Would the cat5 or cat6 need a null pixel still?


Reply
Posts: 944
(@didjareally)
Noble Member
Joined: 12 years ago

How many pixels after the 40'?


Reply
Posts: 28
Topic starter
(@tcraft29)
Eminent Member
Joined: 13 years ago

100


Reply
Page 1 / 2
Share: