Notifications
Clear all
Dec 06, 2022 1:53 pm
iflights wrote:Time to get into serious diagnosis mode here. Do you have a multimeter? You should begin with measuring if you have voltage at the phoenix connector. Lets just start with the 1st one on the board? Measure between G and V+. What do you get?
I will go hide in shame now.
I checked this troubleshooting step earlier in the process, so something else must have been wrong that was fixed later in troubleshooting.
But in the attached picture, I read it as the wires on top (from the R) are the IN wires, and the wires on bottom are the OUT wires. But when I swapped them everything came to life.
I am very, very appreciative of all the help, and very sorry to have used up so much time.
Dec 06, 2022 7:52 pm
Very Good. Now get those lights set up!
Page 4 / 4
Prev

