Not getting full pi...
 
Notifications
Clear all

Not getting full pixel output

6 Posts
3 Users
0 Reactions
1,021 Views
Posts: 41
Topic starter
(@mickisdaddy)
Trusted Member
Joined: 5 years ago
[#56462]

Hello all

I almost have all my pixels going for this Christmas. On my Alphapix Classic from last year I am not getting output on all ports. I have tried everything I can think of so I am coming here to seek help from those more experienced than me.

The controller with the problem is an Alphapix Classic with a RPi4 connected by ethernet cable. The Pi is running FPP 6.0.2. I have attached some screenshots for your perusing.

Controller settings. The IP address when connected to the controller is actually 192.168.1.101. I had to change it to view/change the settings

controller
channel outputs
pihat

xlights config. The FPP that I am having issues on is FPP-House

xlights

Thanks
Sean


5 Replies
Posts: 157
(@neonexpresso)
Estimable Member
Joined: 11 years ago

Your ip in the second screenshot shows 192.168.1.101, not 192.168.0.101


Reply
Posts: 41
Topic starter
(@mickisdaddy)
Trusted Member
Joined: 5 years ago

I had to change the IP of the controller so I could view and change the settings. I get output on ports 1-4


Reply
Posts: 157
(@neonexpresso)
Estimable Member
Joined: 11 years ago

sorry I do see you already mentioned that


Reply
Posts: 79
(@jerryg)
Estimable Member
Joined: 11 years ago

Your port and universe settings on the controller do not look quite correct. You have some over laps happening in because of the 512 channel max on a single universe. Going with a default of 510 channels since you cant the the last pixel in under 512, your ports on the controller will have different universes and start channels. Here is a website to do the calculations and a snip I did based on your setup. Hope it helps. https://www.wiltonlights.com/rgb-pixel-dmx-channel-calculator/

ports

Reply
Page 1 / 2
Share: