Newbie - pixel, pro...
 
Notifications
Clear all

Newbie - pixel, props, controller question

11 Posts
9 Users
0 Reactions
2,623 Views
Posts: 1
Topic starter
(@nitushahus)
New Member
Joined: 4 years ago
[#56630]

Hello,

This is my first year. I am just getting started with ideas and setup.

1) which prop is better? Boscoyo or Gilbert Engineering? I did the comparison (mini trees, spinners etc) and Gilbert Engineering has more nodes per prop for each of the items i compared. YouTube has lots of videos on Boscoyo props, so I am wondering if quality is better with them? Please advice
2) How do you cut pixel string and add a plug? If you have a prop that uses 40 nodes, do you cut off the rest of the nodes that are not used? How does this work? Would it effect the rest of the pixel string? I cant find any instructions on this.
3) Since this is my first year, I am going to buy ready to use Falcon F16v4 controller as I read that it is the easiest to use. Pixelcontroller is out of stock. Is there another good source where I can buy it?

Thank you so much for all your help. I am really excited to have a christmas light show this year!


10 Replies
Posts: 157
(@neonexpresso)
Estimable Member
Joined: 11 years ago

1 - I think you would be happy with either boscoyo or ge.
2 - you can cut them between nodes if you want. the pixels just send the data on to the next one so you can use them how you want. you can then put wire between the 40th and 41st to make it longer, by adding ends or just connecting some similar gauged wire. it really depends on how you wire up your props.
3 - not sure if you can buy elsewhere, but there are other options in stock. they will all take a little bit of learning to use.


Reply
Posts: 373
(@blantrip)
Reputable Member
Joined: 16 years ago

EFL designs also has some nice props.

Another nice controller out there is the Genius Controller by Experience Lights.

Also Kulp controllers.

And many others.


Reply
Posts: 1420
(@1pet2-9)
Noble Member
Joined: 6 years ago

I tend to agree, you will be satisfied with either Boscoyo or GE, but it's because you're in Pleasanton. Boscoyo's models tend to be a little better, but GE is more conveniently near Phoenix whereas Boscoyo is more like Baton Rouge. Shipping matters.


Reply
Posts: 242
(@rsegreto)
Reputable Member
Joined: 6 years ago

I agree, you'll be happy with any of those coro vendors. You can cut and splice these pixels any way you please. You'll get used to soldering in pigtails (end connectors) and running extensions between props. You can solder or use solder and seal sleeves with a heat gun.

Since it's your first year I'd also suggest looking at Kulp controllers. Super easy setup and they have a player built in. If you go with a Falcon you'll still need something like a Raspberry PI running FPP to actually run the show. The Kulp has both of those in one controller and I'm really glad I went that route when I started.


Reply
Page 1 / 3
Share: