New pixel controlle...
 
Notifications
Clear all

New pixel controller

121 Posts
24 Users
0 Reactions
53.2 K Views
kingofkya
Posts: 2165
(@kingofkya)
Noble Member
Joined: 15 years ago

Nice job, just as an fyi a simple rc circuit before the regulator can do wonders for noise. 10ohm resistor and a large cap.

Also data glitches of the pixles you mentioned, I have an idea what that is, the esp is a 3v logic device, the pixels expect a 5v signal they get really iffy around 3v grab a fast schmitt trigger or other buffer type ic and that will fix it an clean up any noise on the output. You can do it with a fet too but they can be harder to get right.

Also let me know if you need any help with a breakout board, with regulator and connection terminals for pixels etc...


Reply
MartinMueller2003
Posts: 7614
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

I am really excited about this device. If it can get 360 pixels per device then each one could handle 2 x 180 pixel arches (60 pixels/meter strips). 🙂


Reply
Posts: 313
(@ee351)
Reputable Member
Joined: 13 years ago
kingofkya wrote:Nice job, just as an fyi a simple rc circuit before the regulator can do wonders for noise. 10ohm resistor and a large cap.

Also data glitches of the pixles you mentioned, I have an idea what that is, the esp is a 3v logic device, the pixels expect a 5v signal they get really iffy around 3v grab a fast schmitt trigger or other buffer type ic and that will fix it an clean up any noise on the output. You can do it with a fet too but they can be harder to get right.

Also let me know if you need any help with a breakout board, with regulator and connection terminals for pixels etc...

It would be great if you could design a breakout board. At this point, I just want to get this tested further to iron out some of the bugs.


Reply
kingofkya
Posts: 2165
(@kingofkya)
Noble Member
Joined: 15 years ago
EE351 wrote:It would be great if you could design a breakout board. At this point, I just want to get this tested further to iron out some of the bugs.

Just a heads up I finished up the schematic for the PCB last night. And will start the PCB layout tonight, one question though what pin are you useign for pixel output tx? gpio2 ?


Reply
kingofkya
Posts: 2165
(@kingofkya)
Noble Member
Joined: 15 years ago

Also as a side note you might want to get your code working with an arduneoish ide, makes it mutch easier for others.
https://github.com/esp8266/Arduino

Also the hackaday.io site it great for documenting your project, or at lest i think so:).


Reply
Page 3 / 25
Share: