Network Wiring with...
 
Notifications
Clear all

Network Wiring with E682

4 Posts
4 Users
0 Reactions
1,643 Views
Posts: 1
Topic starter
(@stevehenshall)
New Member
Joined: 11 years ago
[#40910]

Hi, I'm new to all this and eagerly await my E682 but I'm confused about connecting it to the wired LAN network. I'm running Vixen3 on a pc plugged into the LAN, can I just plug the E682 into a convenient switch, configure it's IP address etc and go? What if I have a second E682? Thanks in advance for any help.

Sent from my iPhone using Tapatalk


3 Replies
TazChaLet
Posts: 3042
(@tazchalet)
Famed Member
Joined: 13 years ago

you might wanna check the wiki for the e682 alot of info on this in there

Routerconnecte131

Reply
Posts: 499
(@frederic)
Honorable Member
Joined: 14 years ago

You assign the E682 an IP address.

When you add additional E682's, you assign each of them a different IP address.

Then in vixen, xlights, or whatever software you are using, you set them to talk to those specific IP addresses.

It's less scarier than it may sound.


Reply
Posts: 825
 DanJ
(@danj)
Prominent Member
Joined: 13 years ago

I ran two E682s for Christmas 2015 and I did just what you asked--I bought a little five port 10/100 switch from HolidayCoro, sent an Ethernet output from my show PC to that switch, then wired it to my two E682s. As noted in other responses, the E682s were assigned different IP addresses. I put a little sticky note on my PC reminding me which IP address was which E682.


Reply
Share: