I have a laptop running a show in Light-o-Rama... I have a Light-o-Rama controller and an alphapix 16 hooked up to the laptop.
The dumb lights from light-o-rama are fine, but my pixels, running through the alphapix have started to have problems.
I did my first floor for halloween just fine without any issues. I added my second floor for Christmas, and now the pixels are randomly having problems, almost like a delay.
When all the pixels are supposed to go off suddenly, some strands will stay lit for a second or two.
When I have a candycane type spiral going along the pixels, where all the pixels are white, and 5 red pixels start traveling across the strand, they will sometimes just remain white while all the other strands do as they are supposed to.
I'm unsure if this is because my laptop isn't powerful enough, or what is going on. I've seen people running the program from raspberry pi's so I doubt my laptop is going to have issues.
Should I convert my light show over to xLights instead?
Any suggestions would be welcomed.
If LOR is anything like Vixen it would render all the effects each time the sequence is run. This creates a lot of work for the system.
Once you export to run from a pi the pi simply pushes out the data to the controllers. There is no heavy lifting for the pi.
It could be the laptop. Always look at power injection if you have pixels playing up.
All of my pixel strands have their own universe and the most pixels I have coming out of any universe is around 150 (450 channels). So i don't think it's really a power issue. I've tried to specifically avoid power injection, as I'm horrible as soldering and general electronics...
(IT guy, not electrician)
