Universe programmin...
 
Notifications
Clear all

Universe programming for megatree on e682

2 Posts
2 Users
0 Reactions
1,232 Views
Posts: 10
Topic starter
(@cliffhanger)
Active Member
Joined: 11 years ago
[#43642]

First year using all 16 ports on my e682 controller and need some help understanding the universe set up. I'm using Vixen3 and I am running a mega tree with 12 strands of 50 pixels, 2 arches with 30 pixels and a two stars with 20 pixels each.

Each port on the e682 will only run one strand. The megatree strands will be on outputs 1-1 through 3-4. The arches will be on 4-1 and 4-2. The stars will be on 4-3 and 4-4.

Now I just need to figure out how to set up the universes. I get that each universe can only do 510 channels so I can do 3 RGB tree strands per universe. (3x50 =150 x 3 = 450 channels)

Using the 450 channels per universe I will need to use 5 universes for my show. That's really as far as I have gotten. I was able to run a test pattern on all strands but it isn't getting the sequence data from Vixen 3. I understand that I will have to change vixen to reflect my controller settings. Just need help figuring out what those setting should be.

Any tips would be appreciated.

Thanks


1 Reply
Posts: 1159
(@deonb)
Noble Member
Joined: 13 years ago

Type in your first universe number and channel on output 1 (or port 1-1 on 5.x) and save.

Whatever it says is the last number (INCLUDING Universe) of that output add 1 and start the next output with that universe and channel (+1).

Rinse and repeat for all 4 outputs / 16 strands


Reply
Share: