Need Help Once agai...
 
Notifications
Clear all

Need Help Once again

2 Posts
2 Users
0 Reactions
1,645 Views
Posts: 21
Topic starter
(@pmjr778)
Eminent Member
Joined: 6 years ago
[#54137]

I have my sequence more or less complete. Tried a couple of strings on the bench and they worked. I completed a coroplast singing tree and followed the wiring layout provided in xlights. Programmed a second espixelstick to run just the tree. Connected it to the tree and when I use the firmware software it lights up correctly. But when I go to xlights, I think my controller isn't setup right. The preview window shows the tree properly functioning but the actual tree lights up like a different part of the model. The 2 pixelsticks use different ip addresses and in visual only the second tree is on the second pixelstick. I'm confused. I can submit pics later if that helps.


1 Reply
TomL8345
Posts: 1356
(@toml8345)
Noble Member
Joined: 15 years ago

This sounds like a setup issue in XLights or the FPP firmware. Those are the first places I would check.

Post screenshots of your XLights setup and the Pixelstick setup pages.


Reply
Share: